Minimally invasive extractions with physics forceps - clinical evaluation and comparison.

INTRODUCTION: Tooth extraction is still one of the most common dental procedures, routinely performed for a variety of reasons. Tooth extraction forceps and elevators are well-known extraction instruments which have been the standard in tooth extraction procedures for well over a hundred years. Physics forceps are one possible alternative, aiming to perform less traumatic and more predictable extractions.

Effect on Cellular Vitality In Vitro of Novel APRF-Chlorhexidine Treated Membranes.

INTRODUCTION: Chlorhexidine (CHX) has been used for some time in clinical practice as a local antiseptic agent with excellent efficacy. The combination of CHX with APRF (Advanced-platelet rich fibrin) membrane has the potential to stimulate tissue regeneration and to provide a bactericidal effect. We hypothesize that this may reduce the rate of infections development and protect cell viability. AIM: The aim of this study was two-fold-to create a stable APRF membrane treated with different concentrations of CHX (0.01% and 0.02%) and to monitor its effect on the viability of PDL cells in vitro. This benefits the introduction of a new protocol for APRF membrane production -CHX-PRF and enriches the available evidence on the effect of this antiseptic agent on PDL (Periodontal ligament) cells. MATERIALS AND METHODS: APRF membranes were prepared by the addition of two concentrations (0.01% and 0.02%) of CHX. Membranes without the antiseptic were also prepared and used as control samples. PDL cells were cultivated on the membranes for 72 h. Cell number and vitality were examined by fluorescent cell viability assays. RESULTS: Our results demonstrated that a concentration of 0.01% CHX allowed the production of a stable APRF membrane. This concentration slightly reduced the viability of PDL cells to 96.7%, but significantly decreased the average number of cells attached to the membrane-149 ± 16.5 cells/field compared to controls -336 ± 26.9 cells/field. APRF-CHX 0.02% membranes were unstable, indicating a dose-dependent cytotoxic effect of CHX. CONCLUSIONS: The introduced novel protocol leads to the production of a new type of APRF membrane-CHX-PRF. The incorporation of an antiseptic into the APRF membrane can improve its bactericidal activity and might serve as an important step for the prevention of postoperative infections.

Immunological Response to Nonresorbable Barrier Membranes Used for Guided Bone Regeneration and Formation of Pseudo Periosteum: a Narrative Review.

Here we review the knowledge on the local biological immunological response (formation of "pseudo periosteum" of the host) to two types of nonresorbable membranes used in the horizontal and vertical alveolar ridge augmentation: the titanium-reinforced polytetrafluoroethylene membrane and the titanium mesh membrane. A literature search was conducted including available in vitro, in vivo, and clinical studies on cellular and molecular immunological response to these two types of nonresorbable membranes, in particular the formation of "pseudo periosteum".

Correlation between Primary, Secondary Stability, Bone Density, Percentage of Vital Bone Formation and Implant Size.

BACKGROUND: This study aims to evaluate whether there is a correlation between implant stability, bone density, vital bone formation and implant diameter and length. METHODS: Ninety patients were enrolled in this study. They underwent a socket preservation procedure with allograft or PRF and after 4 months, a total of 90 implants were placed. CBCT scans were assigned prior to implant placement in order to assess the bone density. During the surgical re-entry, a bone biopsy was harvested with a trephine drill. Immediately after implant insertion, the primary stability was measured. The secondary stability was measured 4 months after implant placement. RESULTS: Primary stability showed a significant positive linear correlation with bone density (r = 0.471, p < 0.001) as well as with percentage of new bone formation (r = 0.567, p < 0.001). An average significant association of secondary stability with bone density (rs = 0.498, p < 0.001) and percentage of newly formed bone (r = 0.477, p < 0.001) was revealed. The mean values of primary stability in all three implant sizes, regarding the diameter of the implants, were similar (narrow 67.75; standard 66.78; wide 71.21) with no significant difference (p = 0.262). The same tendency was observed for secondary stability (narrow 73.83; standard 75.25; wide 74.93), with no significant difference (p = 0.277). CONCLUSIONS: The study revealed a high correlation between primary and secondary implant stability, and bone density, as well as with the percentage of vital bone formation. Implant length and diameter revealed no linear correlation with the implant stability.

Comparison Study of the Histomorphometric Results after Socket Preservation with PRF and Allograft Used for Socket Preservation-Randomized Controlled Trials.

The aim of the present clinical study was to assess and compare the histomorphometric results and efficacy of freeze-dried bone allograft (FDBA) in combination with platelet-rich fibrin (PRF), and PRF as a sole grafting material for socket preservation. Ninety patients in need of tooth extraction and implant restoration were included in this study. The participants were randomly divided into three groups based on post-extraction clinical protocol: socket preservation procedure with allograft in combination with a PRF membrane (PRFm), PRF as a sole grafting material, and a control group. A total of 90 implants were placed four months post-extraction. During the surgical re-entry a bone biopsy was harvested with a trephine drill. Histological samples were prepared and analyzed for percentage vital bone and connective tissue. One-way ANOVA with Bonferroni post-hoc analysis were used to assess the results. Both test groups revealed a significantly higher percentage of vital bone formation compared to the control group. No statistically significant differences regarding vital bone formation and connective tissue quantity between the tested groups were observed (FDBA + PRFm: 3.29 ± 13.03%; and PRF: 60.79 ± 9.72%). From a clinical and histological point of view, both materials in the test groups are suitable for the filling of post-extraction sockets without bone defects. Both of the tested groups revealed a significantly higher percentage of vital bone formation compared to the control group.

Association between Bone Density Values, Primary Stability and Histomorphometric Analysis of Dental Implant Osteotomy Sites on the Upper Jaw.

INTRODUCTION: Sufficient bone volume, as well as the bone quality characteristics are necessary prerequisites to ensure optimal mechanical stability of the implants and subsequent osseointegration. AIM: The aim of the present study was to assess the correlation between bone density values obtained by cone-beam computed tomography (CBCT), the primary stability of dental implants and the histomorphometric analysis of bone quality. MATERIALS AND METHODS: Following tooth extraction, socket preservation with frieze-dried bone allograft or protein-rich fibrin (PRF) was performed on 30 patients with 30 maxillary teeth in the region from second premolar to second premolar. Four months after the procedure, CBCT was used to assess the bone density (Hounsfield units) in the area of extraction. Thirty bone samples were harvested from implant sites using a trephine drill. They were analyzed with Image J software. Immediately after placing the implant, the implant stability quotient was measured using the Osstell Idx device. RESULTS: The results revealed significant correlations between bone density and primary stability along the vestibulo-oral (r=0.392, p=0.032) and mesiodistal axes (r=0.407, p=0.026). Bone density also correlated strongly with the percentage of newly formed bone (r=0.776, p<0.001). CONCLUSION: Bone quality, in terms of bone density measured in CBCT and new bone formation are correlated to the primary stability of the dental implants and vice versa.

Comparative Study between a Novel In Vivo Method and CBCT for Assessment of Ridge Alterations after Socket Preservation-Pilot Study.

The aim of this study was to compare two different methods for evaluation of alveolar bone resorption after the socket preservation procedure. In the current study, 9 patients with a total of nine teeth indicated for extraction were included. Patients received alveolar ridge preservation with allograft (BoneAlbumin™, OrthoSera Dental, Gyor, Hungary) or Platelet-Rich fibrin (PRF). CBCT (Planmeca ProMax 3D, Helsinki, Finland), was taken at 1 week and 4 months after the socket preservation procedure. A 3D scan, obtained with Trios (3Shape, Copenhagen, Denmark) of the alveolar bone of the surgical site and the adjacent teeth at the place of extraction was performed during the surgical procedure, immediately after the graft placement in the alveolar socket, and after 4 months. Virtual study models were generated using the three-dimensional file processing software "Meshlab" (ISTI-CNR Rome Italy). The changes of alveolar height and width were measured and analyzed. Results were taken from both methods. Radiographic examination revealed that the average value of horizontal resorption is 0.6⁻2.4 mm, and vertical resorption is 0.46⁻2.8 mm. On virtual models, the average value for horizontal resorption is 1.92⁻3.64 mm, the vertical resorption value is 0.95⁻2.10 mm. The Trios intraoral scan can provide non-invasive and more accurate quantitative insights into the dimensional changes in the alveolar ridge after the bone remodeling process. More research is needed for verification of these results.

Application of Platelet-Rich Fibrin and Injectable Platelet-Rich Fibrin in Combination of Bone Substitute Material for Alveolar Ridge Augmentation - a Case Report.

BACKGROUND: Different barrier membranes and augmentation techniques are used in oral surgery to recover lost bone structures with varied success. Recently, a combination between bone graft materials and Platelet-Rich-Fibrin (PRF) is implemented in the periodontology and implantology. AIM: The aim of this case report was to assess the possibility for augmentation of the alveolar ridge in the frontal region of the upper jaw, utilizing a combination of bone graft material, injectable platelet-rich-fibrin (i-PRF) and advanced platelet-rich fibrin (A-PRF). MATERIALS AND METHODS: An 18 year-old male with expulsion of tooth 11 and partial fracture of the alveolar ridge was treated with augmentation of the alveolar ridge using bone graft material, injectable platelet-rich-fibrin(i-PRF) and advanced platelet-rich-fibrin (A-PRF). Clinical results were reviewed 4 months after the augmentation and a dental implant was placed. RESULTS: The postoperative period was uneventful. The control CBCT scan showed good organization of new bone allowing placement of a dental implant. CONCLUSION: The successful clinical and radiographic results of the case suggest that using A-PRF and i-PRF can be beneficial for bone augmentation of the alveolar ridge before implant placement.